Clamps and clamps for the carpenter

The right terminal

Depending on the type of processing, the appropriate clamp must be available. if you use a traditional metal vice you can use it as long as you cover the jaws with PVC or with aluminum plates to not mark the wood at the point of grip.

Sergeants and clamps

Thanks to the particular type of clamping they are very quick and practical to use. The jaws are protected by plastic parts to avoid marking the wood. There are several measures on the market from a few centimeters up to two meters.

Clamps for frames

They allow the perpendicularity to be maintained and are therefore useful for creating frames and frames.

Quick-clamping clamps h3>    

Thanks to their shape, the eccentric lever produced holds the pieces in position and they are applied and removed very quickly.

"C" terminals

Normally they are smaller than the sergeants. They create a sturdy fastening but it is necessary to apply soft material to the jaws so as not to damage the surfaces.

Clamping terminals

They lock and indicate exactly where to drill to insert the joining pins.

Superlab

Multiple clamp with independent jaws equipped with quick locking adjustable with three degrees of tension.

Belt clamps

They consist of a strip of plastic material and movable jaws. The tape is tensioned and clamps the jaws around the piece without damaging it.

Bench vice

Existing of different types in metal, the typical one of the carpenter is a wood and hothouse against the bank with a screw mechanism.

U jumper

It is a particular "U" shaped nail that is placed in the head to block the attacks.